Oil change 2014 corolla




Oil change 2014 corolla

Article Navigation:
  • Photo
  • Toyota Parts | Toyota Corolla Maintenance - Oil Change
  • Video
  • RELATED PAGES
  • The Toyota Corolla has long held a reputation for its long-lasting quality. If you aren't sure if you're due for an oil change, and can't remember.

    As stated in the manual, if using synthetic 0W20, oil change interval . I have miles on a Corolla S, I am going to change oil myself.

    Find everything you need to know about your Toyota Corolla in the owners CHANGE VEHICLE Toyota Corolla Warranty and Maintenance Guide.

    Oil change 2014 corolla

    Oil change 2014 corolla

    It was interesting to me that if they're responsible for the repair it's 3k, but if I am it's 5k. Remove Oil Cap Take off the oil fill cap. My dealer seems to have informally agreed to that It's the best lube for your engine, and you can go long oil change interval with this oil. I go for mile oil changes, synthetic notwithstanding.

    Oil change 2014 corolla

    Oil change 2014 corolla

    Oil change 2014 corolla

    Oil change 2014 corolla

    Oil change 2014 corolla

    Oil Change - how often? | Toyota Corolla Forum

    A few compatible cartridge oil filter elements include the following with their part numbers: Warming up the engine will help suspend any contaminants within the old oil and allow it to drain out more quickly. Open the hood, twist off the oil filler cap in the counter clockwise direction and lift up the oil level dipstick an inch or two.

    Removing the cap and pulling up the dipstick will help prevent a vacuum from forming and allow the old oil to drain out more quickly.

    Oil change 2014 corolla

    Raise the front of the vehicle with the floor jack and securely support it with the two jack stands. There is a jack point under the car near the front middle area of the engine bay. It looks like a large metal loop. Locate the silver metal oil drain bolt at the rear edge of the black metal oil pan.

    The bolt head faces towards the back of the car. Move the used oil catch container to underneath the oil drain bolt. Be careful when you remove the oil drain bolt since the old oil may be hot enough to burn your fingers depending on how long you warmed up the engine in the first step. Inspect the metal washer on the oil drain bolt. If it appears to be in good condition, you may choose to re-use it.

    Oil change 2014 corolla

    Otherwise, it should be replaced with a new washer. You can buy new washers at your Toyota dealership or most auto parts stores. Tighten the oil drain bolt with the 14mm socket and ratcheting wrench in the clockwise direction to just past hand tight or about ft lbs of torque. Locate the round black plastic engine oil filter housing. Slide the used oil catch basin to just below the oil filter housing.

    Spin off the oil filter cap and turn it over to drain out the old oil. Carefully pull the old o-ring gasket off the threads on the filter cap and throw it away.

    Dip your pinky finger in some new SAE 0W oil and lubricate the rubber o-ring gasket that was included with the new cartridge oil filter. Lubricating the new o-ring will help it form a better seal and make it easier to remove the cap during the next oil change. Insert the new cartridge oil filter in to the cap until it clicks securely in to place. Use the oil filter wrench to continue tightening the cap in the clockwise direction to just past hand tight or about 18 ft lbs.

    Oil change 2014 corolla

    Double check that the oil drain bolt and oil filter cap are tight before moving on to the next steps. Insert an automotive funnel in to the oil filler hole and pour in about 4 quarts of the engine's 4. The engine oil capacity is 4. It is far better to have less than enough oil in an engine than to over fill it. You may have to pour in the entire 4. Replace Oil Filler Cap Check Dipstick Oil Level Replace Oil Dipstick Temporarily replace the oil filler cap, start the engine, let it run for a few minutes, shut it off, and allow the oil to drain down to the oil pan for at least 5 to 10 minutes.

    Pull the oil dipstick out, wipe it clean, re-insert it and pull it out again to check the oil level. If necessary, slowly pour in more SAE 0W oil while repeatedly checking the level on the dipstick until it reaches just at or below the upper dot which indicates the "Full" or "Maximum" line. Replace the oil filler cap by twisting it on the clockwise direction. You should see 6 dashes start flashing as they disappear and then 6 zeroes will briefly flash on the display.

    Toyota Corolla Oil Change (2015)



    • Подписаться по RSSRSS
    • Поделиться VkontakteVkontakte
    • Поделиться на FacebookFacebook
    • Твитнуть!Twitter

    Leave a Reply

    Return to Top ▲TOP ▲